3D Systems Cube User Manual page 18

NOTE: The print pad must be clean and free from glue and print material.
NOTE: Ensure the print jet nozzles are clean and free from print material. This
can usually be accomplished by pulling out the print material with your
fingers.
Caution: Ensure the print jet nozzles are at room temperature before
attempting to clean them.
1. Select MANUAL GAP
2. Place the gap gauge on top of the print pad under the left print jet. Select the
checkmark to continue.
NOTE: Ensure the left cartridge is installed before performing this procedure.
NOTE: The Gap Gauge is a thin polyester strip approximately 8.5" (216 mm)
long and 1.5" (38 mm) wide.
3. Gently slide the gap gauge back and forth between the print pad and the left print jet.
Using the arrows, raise or lower the print pad until you feel a slight resistance on the
gauge. Select the
Caution: Exercise caution to prevent the print jet from pressing into the print
pad. Once you feel a slight resistance in the Gap Gauge as it moves between
the print pad and the left print jet, the gap is correct.
ADJUSTMENT.
checkmark when you feel the proper resistance.