3D Systems Cube User Manual page 15

4. When prompted, tighten the lock screw enough to ensure the adjustment knob does
not easily turn. Select the
Caution: Do not over-tighten the lock screw. This can damage the adjustment
knob and void the manufacturer's warranty.
5. Reinstall the print pad and select the
again.
NOTE: Select
that Auto Level procedure
6. Once Auto Level is successful, the printer will begin checking the Z-gap.
NOTE: The printer will perform an automated gap measurement. This may
take a few minutes.
checkmark
SKIP to bypass the Auto Level procedure. It is recommended
is performed again.
to continue.
checkmark to perform the Auto Level procedure