3D Systems Cube User Manual page 11

Level The Nozzles
If PLA and INF material do not adhere to one another, check the nozzle level. Print
the nozzle level test file and adjust as needed.
NOTE: Auto Level should always be performed before the Auto Gap
procedure.
NOTE: Auto Level should be performed when the printer is positioned away
from bright lights or direct sunlight.
Auto Level
1. Navigate to the Print Plate Calibration screen and select
2. Clean the print pad thoroughly removing all glue and debris. Select the
continue.
NOTE: The surface of the print pad must be completely clean.
AUTO LEVEL.
checkmark to