3D Systems Cube User Manual page 16

7. Select the checkmark
NOTE: If Auto Gap is not successful, it is recommended that you perform Auto
Level and Auto Gap again. Select
NOTE: If Auto Gap is not successful the second time, select
MAINTENANCE. For more information, refer to the section titled
Maintenance. Once the Plate Maintenance procedure has been performed,
perform Auto Level and Auto Gap.
NOTE: If Auto Gap is still not successful, select
Refer to the section titled
the Manual Gap Adjustment procedure has been performed, note the final
reading for future reference.
Gap Verification
Print a test print from the System 1 menu. Once you have removed it from the print
pad, visually inspect the first (bottom) layer of the print and verify the quality. Turn
the print upside down and inspect the printing grain. When the gap is optimal, the
bottom of the print should appear smooth and the lines should be very light and
fused together.
Correct Gap
The gap is correct when the bottom of the print appears smooth and the lines are
tightly fused together.
to continue.
AUTO LEVEL
Manual Gap Adjustment
to continue.
PLATE
Print Pad
MANUAL GAP ADJUSTMENT.
for more information. Once