Configuring Snmp Support On Linux; Configuring Snmp Support On Netware - Adaptec RAID 3085 User Manual

Configuring SNMP Support on Linux

For the Linux operating system, the Adaptec Storage Manager SNMP agent is a sub-agent that
interfaces with the UCD-SNMP agentx architecture. UCD-SNMP is a third-party package for
Linux; for information, documentation, and downloads, see www.net-snmp.org.
To configure SNMP support:
1
Install Adaptec Storage Manager (see
2
Add Adaptec OID information and agentx extension information to the snmp.conf.
3
Delete
/var/agentx/master
4
Start the snmpd daemon and agentx.
5
Start aus-snmp daemon.
Refer to your Linux documentation for information on configuring UCD-SNMP, agentx, and
setting up traps.

Configuring SNMP Support on NetWare

To install Adaptec Storage Manager SNMP support, at the command prompt type this
command, then press Enter:
load AUSSNMP.NLM
Refer to your NetWare documentation for information on configuring traps.
Chapter 12: Configuring SNMP Support
page 23).
(socket file for agentx).
133
●