Creating a Logical Drive Using Available Space
Free segments on a disk drive can be used to create a new logical drive. (A segment can only be
used in one logical drive at a time.)
To create a logical drive using free segments on disk drives:
1
Complete Steps
1
through
2
In the Physical Devices panel, select the disk drives and/or free disk drive segments you
want to use in the logical drive.
Note:
Adaptec recommends that you not combine SAS and SATA disk drives within the same
logical drive. Adaptec Storage Manager generates a warning if you try to create a logical drive
using a combination of SAS and SATA disk drives.
In this example, two free disk drive segments (indicated in blue) are used to create a RAID 1
logical drive.
3
Click Next.
4
Review the logical drive settings.
5
Click Apply, then click Yes.
Adaptec Storage Manager builds the logical drive. The configuration is saved in the
Adaptec controller and in the physical drives.
Chapter 6: Managing Logical Drives and Hot Spares
5
in
Custom Configuration (Advanced) on page
71
●
49.
Free segments
and available
disk drives are
blue