Configuring SNMP Support on Linux
For the Linux operating system, the Adaptec Storage Manager SNMP agent is a sub-agent that
interfaces with the UCD-SNMP agentx architecture. UCD-SNMP is a third-party package for
Linux; for information, documentation, and downloads, see www.net-snmp.org.
To configure SNMP support:
Install Adaptec Storage Manager (see
1
Configure the UCD-SNMP master agent to be used with agentx.
2
Start the Adaptec Storage Manager SNMP sub-agent:
3
From the Adaptec Storage Manager installation directory, run the aus-snmpd executable.
Refer to your Linux documentation for information on configuring UCD-SNMP, agentx, and
setting up traps.
Configuring SNMP Support on NetWare
To install Adaptec Storage Manager SNMP support, at the command prompt type this
command, then press Enter:
load AUS-SNMP.NLM
Refer to your NetWare documentation for information on configuring traps.
Appendix A: Configuring SNMP Support
page
22).
128
●