Pedal And Other Controller Settings - Korg NAUTILUS Series Operation Manual

Pedal and other controller settings

The GLOBAL > Controllers/Scales– Controllers page lets
you control how the footswitches and foot pedal will work.
Setting up the Assignable Switch and
Pedal
Assignable Switch
Foot Switch Assign lets you assign a function to a
footswitch (such as the optional Korg PS-1) connected to the
rear-panel ASSIGNABLE SWITCH jack.
You can choose from the following functions:
• AMS (Alternate Modulation) source for controlling
sounds
• Dmod (dynamic modulation) source for controlling
effects
• Portamento on/off
• Sostenuto
• Soft pedal
• Step up or down through sounds, including Programs,
Combinations, and Set List Slots
• Start/stop the sequencer
• Punch-in/out on the sequencer
• Tap tempo
• Arpeggiator on/off, Latch on/off
• Drum on/off
• Select min and max values for controllers, including the
joystick, and knobs.
Global Settings Pedal and other controller settings
Assignable Pedal
You can specify the function that will be performed by an
assignable pedal (the optional XVP-20 VOL/EXP pedal or
EXP-2 foot controller) connected to the ASSIGNABLE
PEDAL jack.
This is controlled by the Foot Pedal Assign parameter.
You can choose from the following functions:
• Master volume
• Alternate modulation source
• Effect dynamic modulation source
• Portamento pitch change speed
• Volume
• Pan
• Pan (following insert effects)
• Send levels to the master effects
• Duplicate the function of another controller, such as the
joystick
Note: You can use this as a source for alternate modulation
or effect dynamic modulation, and use it to control program
parameters or effect parameters. In this case, set Foot
Switch Assign to Foot SW (CC#82), and Foot Pedal
Assign to Foot Pedal (CC#04).
Changing Programs and Combinations with the
foot switch
1. Press the Foot Switch Assign popup button, and select
either Program Up or Program Down.
Program Up will cause the next higher program number
to be selected each time you press the foot switch.
Program Down will cause the next lower program
number to be selected each time you press the foot
switch.
2. Set the "Foot Switch Polarity" to the polarity of the
foot switch you have connected.
If you have connected a Korg PS-1 pedal switch, set this
to (–) Korg Standard. If the polarity is not set correctly,
the pedal will not function appropriately.
3. Either press the MODE button and select PROGRAM
mode to enter PROGRAM > Home, or select
COMBINATION mode to enter COMBINATION >
Home.
When you press the foot switch, the program/
combination will change.
175