Table of Contents
Advertisement
Sampling and editing in SAMPLING mode Creating multisample indexes and sampling–Recording
4. Press the Create button to create an index.
Immediately after the power is turned on, Index will
show 001/008. This indicates that there are eight indexes,
and that the first index is selected (see the illustration
below).
Press the Create button several times. Each time you
press it, an index will be created. The keyboard display
will indicate the zone and original key location of each
index.
Note: The index that is created when you press the Create
button will be created according to the Recording–
Recording page Create Zone Preference settings. (These
settings can also be made in Multisample Edit page, Cre-
ate Zone Preference)
Immediately after the power is turned on, Position will
be Right (to selected index), Zone Range will be 1 Keys,
and Original Key Position will be Bottom, so that
indexes will be created as shown below. This is
convenient when you want to sample multiple takes of a
phrase or rhythm loop in a single operation.
If you set Zone Range to 12 Keys, indexes will be
created at intervals of one octave.
5. Select "Index."
You can also select Index by holding down the ENTER
button and playing a pad or a note on the keyboard. For
this example, select 001.
6. Assign a sample to the "Index."
If RAM memory already contains samples, use Sample
Select to select the sample and assign it.
If you want to record a new sample, you can sample it
now.
The sample you record will be automatically assigned to
the index you selected in step 4.
The assigned sample will sound when you play the
keyboard in the range of the index to which the sample is
assigned.
7. Repeat steps 5 and 6 to assign a sample to each index.
The number and order of the indexes in a multisample,
the range of each index, and the original key position can
be freely changed later if desired. (See "Multisample
editing" on p.143)
Creating multiple samples
In the example procedure described above, several indexes
were created (by pressing the Create button several times),
and then samples were assigned to each Index.
As an alternative method, it is also possible to create one
index, sample into it, and then repeat these two steps.
1. Press the Create button once to create an index.
2. Record a sample.
The recorded sample will automatically be assigned to
the index you created in step 1.
3. Repeat steps 1 and 2.
This is an efficient way to record multiple samples.
133
Advertisement
Table of Contents
