Editing User Sample Banks - Korg NAUTILUS Series Operation Manual

Editing User Sample Banks

At any time, you can load a User Sample Bank's data into
SAMPLING mode and edit the Samples or Multisamples as
desired, or add new Samples or Multisamples. To do so:
1. If the data is already loaded as a User Sample Bank,
use the "Unload all in bank" command on the Global
Sample Management page to unload the data before
proceeding.
For more information, see "Unloading an entire bank of
data" on page 644 of the PG.
2. Go to the folder in which you've saved your KSC from
"Saving User Sample Banks," above.
3. Select the "[name].KSC" file—the one without
"UserBank" in the name.
4. Press the Load button.
The Load KSC dialog will appear.
5. Set .KSC Allocation to Clear Sampling Mode Data.
This is important, in order to preserve the User Sample Bank
ID. For more information, see "User Sample Bank IDs,"
below.
6. Press OK to load the data.
7. Edit as desired, but don't change the numbering of
existing Multisamples (or Samples, if you've used
them for Drum Kits). If you add new Multisamples or
Samples, add them at the end of the list.
Programs, Wave Sequences, and Drum Kits refer to
Multisamples and Samples by their number in the bank. To
make sure that existing sounds continue to work properly,
keep that numbering the same.
8. Save the KSC.
For details, see "Saving User Sample Banks," above.
User Sample Banks Editing User Sample Banks
155