Table of Contents
Advertisement
Creating songs (SEQUENCER mode)
Overdub
With this method, the newly recorded musical data is added
to the existing data.
When you perform overdub recording on a previously-
recorded track, the newly recorded data will be added to the
previously-recorded data.
It is best to select this mode if you will be recording
additional control data, recording a drum pattern, or
recording the tempo in the master track. With this mode,
data can be added without erasing the existing performance
data.
1. Use "Track Select" to select the track that you want to
record.
2. Set the Recording Setup to Overdub.
3. For the rest of the procedure, refer to steps 3–5 of
"Overwrite."
Manual punch-in
While the song is playing, you can press the SEQUENCER
REC button or a connected pedal switch at the desired
location to start or stop recording. With this method, the
musical data previously on the track is overwritten by the
newly recorded data.
1. Use "Track Select" to select the track that you want to
record.
2. Set the Recording Setup to Manual Punch In.
3. In "Location," specify a location several measures
earlier than the point at which you wish to begin
recording.
4. Press the SEQUENCER START/STOP button.
Playback will begin.
5. At the point at which you wish to begin recording,
press the SEQUENCER START/STOP button.
Recording will begin. Play the keyboard and operate
controllers such as the joystick to record your
performance.
80
6. When you finish recording, press the SEQUENCER
START/STOP button.
Recording will end (playback will continue).
Note: Instead of pressing the SEQUENCER REC button
in steps 5 and 6, you can use a foot switch connected to
the ASSIGNABLE SWITCH jack.
Set the GLOBAL > Controllers/Scales page "Foot Switch
Assign" to Song Punch In/Out. For more information, see
"Setting up the Assignable Switch and Pedal" on
page 175.
7. Press the SEQUENCER START/STOP button.
Playback will stop, and you will return to the location that
you specified in step 3.
Auto punch-in
First you must specify the area that will be re-recorded. Then
recording will occur automatically at the specified area.
With this method, the musical data previously on the track is
overwritten by the newly recorded data.
1. Use "Track Select" to select the track that you want to
record.
2. Set the Recording Setup to Auto Punch In.
3. In "M (Auto Punch In Start Measure), "M (Auto
Punch In End Measure)" specify the area that you
wish to record.
For example if you specify M005–M008, recording will
occur only from measure 5 to measure 8.
4. In "Location," specify a location several measures
earlier than the point at which you wish to begin
recording.
5. Press the SEQUENCER REC button, and then press
the SEQUENCER START/STOP button.
Playback will begin.
When you reach the starting location you specified in step
3, recording will begin. Play the keyboard and operate
controllers such as the joystick to record your
performance. When you reach the ending location you
specified in step 3, recording will end. (Playback will
continue.)
6. Press the SEQUENCER START/STOP button.
Playback will stop, and you will return to the location you
specified in step 4.
Advertisement
Table of Contents
