Table of Contents
Advertisement
Appendices
O (Obey copyright rules–Oscillator)
Oscillator Mode conflicts
(Check PROG mode: Program Basic Page)
Meaning: In SAMPLING mode when you executed
Convert MS To Program with Use Destination Program
Parameters checked, the conversion destination program
Oscillator Mode setting did not match.
P (Pattern–Program)
Pattern conflicts with events
Meaning: It was not possible to execute the Bounce
operation because one of the tracks contained a pattern, and
the same measure of the other track contained events or a
pattern.
• Open the pattern.
Pattern exists across destination to-end-
of-measure or source from-measure
Meaning: When moving a measure, the edit operation could
not be executed because a pattern had been put in the
destination end measure or the source start measure, and had
not been opened.
• Open the pattern.
Pattern exists in destination or source
track
Meaning: A pattern has been placed in the track that you
specified as a destination or source for editing. If you wish to
open the pattern and execute (the events of the pattern will
be copied), press the OK button. If you wish to execute
without opening the pattern, press the Cancel button.
Q (Quick Layer/Split function)
Quick Layer/Split Caution
Meaning: This message may appear when you execute the
Quick Layer or Quick Split function.
• "There is not enough empty slot to copy Layer's IFX."
This message appears if there are not enough insert effect
slots, so that the insert effect settings of the layer/split
program cannot be copied.
• "Main's active T# was replaced for Layer."
• "Main's active T# was replaced for Lower/Upper."
• "Main's active T# was replaced for Drum Track."
This message appears if there were not enough unused
timbres in the main combination, indicating that one of them
was replaced by the layer/split program.
250
• In PROGRAM mode, set the Oscillator Mode of the
Pattern used in song
Meaning: When editing, the specified pattern has been
placed in a track. If you wish to execute, press the OK
button. If you decide not to execute, press the Cancel button.
Program Bank Type conflicts
Meaning: When receiving a dump of an individual bank or a
single program, the NAUTILUS received a program that did
not match the bank type. If the bank type does not match, the
program will not be received.
Meaning: When receiving an All Programs dump, the
NAUTILUS received a bank whose bank type did not match.
Only banks of the matching bank type will be received.
• Use the Set Program User -Bank Type command
Open pattern?
Program Type conflicts
Meaning: This message will appear when you execute Copy
Tone Adjust if the copy-source and copy-destination
program types are different. You cannot copy between HD-1
and EXi Programs, or between different types of EXi
Programs.
The Quick Layer/Quick Split function does not allow you to
make adjustments for insufficient insert effects or timbres. If
necessary, you can execute Write Combination, and then edit
the combination in COMBINATION mode.
conversion destination program. If converting a
monaural multisample, select Single. If converting a
stereo multisample, select Double.
(GLOBAL > Basic Setup– Basic page Page Menu
Commands) to change the bank type so that it's the same
as the one being transmitted, and then try the operation
again.
Continue?
Advertisement
Table of Contents
