Korg NAUTILUS Series Operation Manual page 214

Loading & saving data
Memory protect
Memory Protect lets you prevent certain types of data from
being overwritten accidentally. There are individual check-
boxes to enable Memory Protect for different parts of the
system, as described below.
For Programs, Combinations, Songs, Set Lists, Drum Kits,
Wave Sequences, and Arpeggio Pattern, Memory Protect
prevents:
• Using the Write command to save edits
• Loading the data type from drive
• Receiving dumps of the data type via MIDI SysEx
When enabled for Songs, Memory Protect also prevents
recording in SEQUENCER mode.
When enabled for Internal HDD Save, Memory Protect
prevents saving any data to the internal drive.
Before saving edits, loading data, and so on, use the
following procedure to turn the memory protect off.
1. Press the MODE button to select GLOBAL mode.
2. Go to the GLOBAL > Basic Setup and select the Basic
page.
3. Press the "Memory Protect" check box for each type
of data you wish to write or save, so that the box is
unchecked.
208
Writing Global settings
Any edits in GLOBAL > Basic Setup, MIDI,
Controllers/Scales, Category Name are temporary until you
use the Write command to store them in the internal
memory. If you don't use the Write command, your changes
will be gone when you turn off the power.
(Note that Wave Sequences, Drum Kits and Arpeggio
Pattern are stored from the other Global parameters.)
When you Write, the
various GLOBAL > Basic
Setup, MIDI,
Memory Area
Controllers/Scales,
Category Name settings
will be saved in internal
Write
memory.
Internal Memory
Global Setting
Basic Setup...Category
Using the Write page menu command
1. To write global settings (the various settings in
GLOBAL > Basic Setup, MIDI, Controllers/Scales,
Category Name), press the page menu command
Write Global Setting in GLOBAL > Basic Setup,
MIDI, Controllers/Scales, Category Name.
The Write Global Setting dialog box will appear.
2. To execute the Write operation, press the OK button.
To cancel, press the Cancel button.
When you press the OK button, the display will ask "Are
You Sure ?" Press the OK button once again to write the
data.
Editing will affect the data that has
been called into the memory area.
Edit
When the power is
turned on, the settings
are called into the
Power On
memory area.