Basic Examples Of Sampling - Korg NAUTILUS Series Operation Manual

Sampling (Open Sampling System)

Basic examples of sampling

Sampling your voice from a mic, and
playing it back as a one-shot sample
In this example, we'll use a mic connected to Audio Input 1
to sample your voice.
Connect a mic
1. Connect a mic to the rear panel Audio Input 1 jack.
2. Adjust the Analog Input Setup dialog (SHIFT and
AUDIO IN buttons) so that it's in the MIC position,
and set the Analog Input Gain near the center.
Sampling Setup
1. Go to the SAMPLING > Recording– Audio Input
page.
Press the MODE button to select SAMPLING mode.
Make sure that the SAMPLING > Recording page is
displayed.
If it is not, press the EXIT button, and then press the
Audio Input tab.
2. Choose the menu command "Auto Sampling Setup."
A dialog box will appear. Auto Sampling Setup
automatically sets many of the parameters necessary for
sampling. You can use these settings as a guideline when
sampling.
134
Mic
3. Select "REC Audio Input."
This will make settings for sampling an external audio
source.
4. Set "Source Audio" to Audio Input 1/2.
This means that you'll be sampling the instrument or
other external audio input source connected to Audio
Inputs 1 and 2.
5. To the right of Source Audio, select L-Mono.
With this setting, the input from the INPUT 1 jack will be
sent to the internal L-channel and sampled monaurally.
6. For the "Save to" field, select RAM.
The sampled data will be written into RAM memory.
7. Turn "IFX" Off.
You will be sampling without applying an insert effect.
8. Press the OK button to execute the command.
You have now made the settings necessary for sampling.
Note: Take a look at the settings that have been made.
Recording– Audio Input page
Audio In: On
– INPUT1 –
"Bus Select" L/R
Pan: L000
Level: 127
Set the INPUT 1 jack's input level, pan and send
destination on the L/R bus.
– Sampling Setup –
Source Bus: L/R
The sound sent to the L/R bus will be sampled.
Trigger: Sampling START Button
Sampling starts when you press the SAMPLING
START/STOP button.
Recording Level: +0.0
This is the default setting for recording external inputs.
Recording– Recording page
– REC Sample Setup –
Save to: RAM
Samples the sound to RAM.
Sampling Mode: L-Mono
This samples the sounds in mono that are coming in
through the internal L channel.