Loading Individual Banks From A .Pcg File - Korg NAUTILUS Series Operation Manual

Loading individual banks from a .PCG file

1. Select the .PCG file containing the data you want to
load.
Refer to steps 1–4 of "Loading Songs, sounds, and
samples together" on page 213." Select the .PCG file in
step 4.
2. Press the Load button.
You can load individual banks by using ".PCG Contents"
in the dialog box to select the load-source bank, and "To"
to select the load-destination bank.
When you press OK, the source bank's Programs,
Combinations, Drum Kits, Wave Sequences and
Arpeggio Pattern will be loaded into the destination bank.
Global setting data will not be loaded.
If you set ".PCG Contents" to Bank A, and "To" to Bank
A, data will be loaded as follows.
Programs
• Bank A: loaded into Bank A
Combinations
• Bank A: loaded into Bank A
Drum Kits
• A: loaded into Bank A
Arpeggio Pattern
• A: loaded into Bank A
Wave Sequences
• A: loaded into Bank A
Loading data from disk Loading individual banks from a .PCG file
When data is loaded into a bank that is different than its
original bank, the data (bank, program, pattern, and kit
numbers, etc.) will automatically be reconfigured so that
after loading, the various types of data will correspond
correctly in each mode.
The following data will also be reconfigured automatically if
you have checked "Load .SNG too" (so that song data is
loaded at the same time), the following data will also be
reconfigured automatically in order to ensure that the song
data plays back correctly.
• The bank of each program used by combinations
• The bank of each drum kit and Wave sequence used by
each program
• The bank of the program used by each track of the song
• If the song contains track/pattern events, the program
banks within these events
215