Korg NAUTILUS Series Operation Manual page 179

Bypassing the effects
Insert effects, master effects, and total effects can be
bypassed globally. This applies to the entire NAUTILUS
regardless of the mode. For example, if you've connected
the NAUTILUS's outputs to an external mixer and are using
an external effect processor to apply reverb or chorus to the
sound, you can turn off the NAUTILUS's master effects and
total effects.
If the Effect Global SW IFX 1–12 Off, MFX1&2 Off, and
TFX1&2 Off items are checked, the insert effects, master
effect, and total effects will respectively be bypassed.
Globally disabling Arpeggiator and the
Drum Track/Step Sequence
If All ARP Off is checked, all ARP functionality will be
disabled. Arpeggiator will not play even if the ARP button is
on.
Similarly, If All drum Off is checked, all Drum
functionality will be disabled. The Drum will not play even
if the DRUM button is on.
Interaction between Transpose and Scale
The Osc/Timbre/Track Transpose parameter determines
how the Program Oscillator, Combination Timbre, and Song
Track Transpose parameters interact with the Scale and Key.
There are two options, each designed for a specific use-case.
If you are using non-equal-tempered scales and want to build
parallel intervals (such as "fat fifths") into your sounds, use
the Works Within Scale (for harmonies) setting.
If, on the other hand, you play in non-equal-tempered scales
and transpose entire songs—to accommodate singers, for
example—use the Transposes Scale option.
For more information, see "Osc/Timbre/Track Transpose"
on page 632 of the PG.
Tuning and transpose
settings
Velocity/aftertouch curve
settings
Select the mode that is
selected at power-on
Global Settings Basic Setup
Recalling the last-selected mode and
page at power-on
The state of NAUTILUS when the power is turned on will
depend on the setting of Power On Mode.
If Power On Mode is set to Reset (the default), NAUTILUS
will automatically select the SET LIST > Play page.
If Power On Mode is set to Memorize, NAUTILUS will
power on using the same mode and page that were selected
when the power was turned off.
Protecting the memory
If one or more of the Memory Protect check boxes are
checked, operations such as writing, loading, or song
recording will be prohibited for the corresponding type of
memory.
Adjusting the brightness of the LCD
You can adjust the appearance of the LCD display by using
the LCD Setup menu command, on the GLOBAL > Basic
Setup page. To do so:
1. Press the MODE button to select GLOBAL mode.
2. Press the PAGE button and choose Page Select.
The Basic Setup page will appear.
3. From the page menu located in the upper right of the
LCD, choose LCD Setup.
The LCD Setup dialog will appear.
4. Set the brightness as desired.
5. Press the OK button to confirm the changes, or press
the Cancel button to revert to the previous settings.
ARP/DRUM
settings
Effect bypass
settings
Memory protect
settings
173