Toshiba ER-LD430C Instruction Manual page 51

※
On pressing ,
it is the cycle change to
Accessories usege
Refer to cooking book for combination
Without preheat
1
Prepare the water
supply and press
after placing the food ※
・Refer page 13 for guideline on water tank preparation.
・ Insert the water supply cassette till the cassette touches the rear end.
2
Rotate
press for decision
・Set temperature：100〜250℃ , 300℃
When machine is hot （ Display part will show 「 HIGH TEMP」 with blinking
light） , since an electric preventive device can not be set over 300℃
3
Rotate
・Maximum time : 60 min.
4
Press
Heating start
The buzzer will beep 3 times when finish.
・If you forgot to take the food out, the buzzer will beep 5
times in an interval of one minute. The beep will stop on
press [Cancel] and open the door.
・LCD displays [HIGH TEMP]
・Be careful when you take the food out as the oven
chamber and the square tray will be hot. Be careful as hot
steam escapes from steam exit outlet.
Steam after steaming...
steam
（Refer page 55 for About Cleaning）
Tips
・ Be careful of steam that escape when opening the door to take
the food out.
・ If the door is opened during cooking, some steam may escape
out. Be careful of the steam coming out from steam exit outlet.
・During Hybrid convection cooking, if the cooking is complete
earlier than the set time, the end result may vary.
Steamed
Hybrid
（without preheat）
Superheated steam...
Steam is further heated with a heater. Cooks using this steam (superheated
steam) that is above 100℃ . This cooking method removes the oil and fats
from the surface of the food and provides healthy food.
Hybrid...
Removes oils and fats with superheated steam. Browning is done with a
high output heater.
※ Due to the high temperature, superheated steam is not visible to the eye.
Superheated steam
Press 5 times
（without preheat）
Press 7 times
（without preheat）
to set temperature and
knob to adjust the time.
Proper temp steam
Hybrid Superheated steam
（with preheat） （without preheat）
Preheat is ...
・ To heat the empty oven chamber and keep it warm at
a particular temperature required to cook the dish.
Hybrid
■Change temperature during preheat.
→It is impossible.
■Relation between the set temperature
and preheating temperature.
→Preheating at the same temperature as set
But if setting temperature at 300℃ upward,
preheating temperature will be 250 ℃ .
■Preheating timing
→When set to 250℃ , approximately 10 minutes
When set to 200℃ , approximately 5 minutes
・ The preheat temperature will somewhat
vary depending on the temperature
inside the oven, room temperature and
electrical voltage before preheating.
■Setting unit of cooking time
0
30sec.interval 1min.interval
■To adjust the time during cooking.
→ R o t a t e t h e k n o b t o i n c r e a s e o r
decrease time at 1 minute interval
during cooking.
・ The maximum time set initially is 60 min.
and include the possible increase in time.
■To adjust the temperature during cooking.
→ The dial is pressed during heating, and
while
to increase or decrease by 10℃
・ During hybrid operation, temperature cannot be
changed if the remaining time is less than 2 minutes.
■ If the water in the water tank become empty while cooking.
→ There will be a beep and the [WATER] display
will start blinking. Add water in the water tank.
[WATER] display will disappear once water
is added. (Water can be added to the water
tank, even during cooking operation.)
■ For further heating, once cooking is complete. [EXTENSION]
→ This is done by rotating the dial to set the
time within 1 minute after the completion of
cooking and the process has to be monitored.
Superheated Steam is not
visible to the eye, be careful.
Microwave steam
Superheated steam
（with preheat）
15min 40min 60min
5min.interval
is flashing, the dial is rotated
49