Toshiba ER-LD430C Instruction Manual page 36

Auto cooking by Auto menu
Basic operations of the dial menu
The basic operations of the dial menu have been explained.
See the tips for effective use given in pages 36 and 37.
Basic operations
（※The operations may vary depending on the menu. See the separate cuisine booklet and proceed with the operations)）
1
Place the food into the chamber.
・Place the food in the specified location.
・ Prepare water supply for the menus that are marked with
・Refer page 13 for guideline on water tank preparation.)Insert the water supply cassette till it touches the rear end.
2
Rotate
3
Press
The buzzer will beep 3 times when finish.
●LCD displays [HIGH TEMP]
Open the door and take the food out.
● If you forgot to take the food out, the buzzer will beep 5 times in an interval
of one minute.The beep will stop on press [Cancel] and open the door.
Steam After steaming...
steam
■ Heat Adjustment
→ Can be increased or decreased by turning the dial to [INCREASE]
or "DECREASE" within 15 seconds of starting.
・ Turn right [Increase] and left [Decrease]
for selection. Increase and Decrease can
be select 1,2,3 levels both.
■ For further heating,
once cooking is complete. [EXTENSION]
→ This is done by rotating the dial to set the time within 1 minute after
the completion of cooking and the process has to be monitored.
・However, [CLEANING] cannot be extended.
34
to select Auto Menu.
button.
The time remaining is displayed from the middle of the process
START ! START !
（Refer page 55 for About Cleaning）
DECREASE
in the separate cuisine booklet.
・ The LCD display shows the Auto Menu list number
from 12〜49. Choose the menu number.
In addition, automatic menu lights up for the relevant category.
Display : Sponge cake
Since the square tray etc will be hot,
take care while removing the container.
In addition, be careful as there will be
steam coming out of the outlet port
after steam cooking.
■ To increase or decrease the time during the cooking
（Only for menu12, 13, 15〜27, 29〜39）
→ when the remaining time is displayed, rotate the
INCREASE knob to increase or decrease the time by 1 minute.
・ timing for menu 13, 17, 21 can be
changed only during open heating.
■ If the water in the water tank become
empty while cooking.
→ There will be a beep and the [WATER] display
will start blinking. Add water in the water tank.
・ [WATER] display will disappear once water is added.(Water can
be added to the water tank, even during cooking operation.)
For accessories,
see dial menu list
（P.32〜33）
DECREASE INCREASE