Toshiba ER-LD430C Instruction Manual page 45

Accessories usege
Refer to cooking book for combination
Without preheat
1
Food is placed
2
Press
・ will not be displayed in the display unit
3
The temperature is adjusted by rotating
and confirmed by pressing.
・Set temperature：100〜300℃ , 350℃
When machine is hot （ Display part will show 「 HIGH TEMP」
with blinking light） , since an electric preventive device can
not be set over 260℃
4
Rotate
・Maximum time : 90 min
5
Press
Heating start
The buzzer will beep 3 times when finish.
・If you forgot to take the food out, the buzzer will beep
5 times in an interval of one minute.
The beep will stop on press [Cancel] and open the door.
・LCD displays [HIGH TEMP]
・As the oven body and square tray are hot, please hold
with care when remove.
Tips
・ Depending on room temperature, initial temperature of food and the electric voltage, the final result may vary.
・ To ensure best results, reshuffle the food during the heating process and shield certain parts with aluminium foil.
Convection...
Grills the food efficiently with circulation of strong hot air.
Setting temperature
The setting temperature of the oven is measured at the centre of the oven
chamber using a thermoelectric thermometer. (JIS measurement method is used)
The temperature may not match if the temperature is measured using
commercially available thermometers
twice ※
adjust the time
Preheat is ...
・To heat the empty oven chamber
and keep it warm at a particular
temperature required to cook the dish.
■Change in temperature during preheating
→It is impossible.
■Relation between the set temperature
and preheating temperature.
→Preheating at the same temperature as set
But if setting temperature at 260℃ upward,
,
preheating temperature will be 250 ℃ .
■Preheating timing
→When set to 250℃ , approximately 10 minutes
When set to 200℃ , approximately 5 minutes
・ The preheat temperature will somewhat
vary depending on the temperature
inside the oven, room temperature and
electrical voltage before preheating.
■Setting unit of cooking time
0 15min 40min
30sec.interval 1min.interval
■To adjust the time during cooking.
→ The dial can be rotated to increase or
decrease in steps of 1 minute during heating
・The maximum time set initially is 90 min.
and include the possible increase in time.
■To adjust the temperature during
cooking.
→The dial is pressed during heating, and
while is flashing, the dial is rotated
to increase or decrease by10℃
■ For further heating, once cooking is
complete. [EXTENSION]
→ This is done by rotating the dial to set the
time within 1 minute after the completion of
cooking and the process has to be monitored.
90min
5min.interval
43