Table of Contents
Advertisement
9. When finished making any changes, select save and enter the file name if
prompted. Select Connections, Configuration, Write Configuration. When it is
complete, select Connection, Disconnect. Press the TEST pushbutton to verify
that everything is functioning correctly.
Creating a new Configuration
New configurations may be created both on-line (connected to an Annunciator)
or off-line.
1. Start the configuration software and select File, New. Select the correct type of
Annunciator if prompted.
2. The Annunciator Configuration Wizard will start up allowing you to make all
configuration selections.
Note: When creating a new configuration, make sure you select the correct
System Size (rows high x columns wide) and Window Size (1, 2, 3, 4 windows
per cell), otherwise, it can disrupt all settings.
3. Select all configuration choices desired (reference the next section for a
complete description of choices). When done, save the file.
Note: Some options, such as Modbus, DNP, and CSM Relays will not be shown
in the 'New' file configuration. Once you connect to the Annunciator, it will
indicate which options are available.
4. If off-line during the configuration, you can connect the PC to the Annunciator
and download the configuration. (Select Connections, Configuration, Write
Configuration.)
5. After you connect to the Annunciator, you may be prompted to configure certain
options not present in your configuration. You can configure these options if
desired and then save the file when done. Select Connections, Configuration,
Write Configuration. When it is complete, select Connection, Disconnect. Press
the TEST pushbutton to verify that everything is functioning correctly.
Series 90B ANNUNCIATOR INSTALLATION AND CONFIGURATION MANUAL
i.
55
Advertisement
Table of Contents
