Modbus Addresses; Default Values - Ametek 90B Series Installation And Configuration Manual

Modbus Addresses

Conventional addresses are included in the configuration. The input and output
functions here are the most commonly used and refer to a system in slave
configuration.
Conventional Start address
00000
10000
30000
40000*
60000
*Supported in the SERIES 90B

Default Values

Designation
Modbus Address
Receive Start
Address
Transmit Start
Address
Modbus Mode
Data type
Baud rate
Parity
Transmit controls
Data direction
Modbus format
110
Data
Output Coils
Discrete Inputs
Input Registers
Holding (output)
Registers
Extended Memory
Options Default
0-255 01
40001-49999 40001
40001-49999 40001
Master/Slave Slave
AN3135 Point
/Point/State
2400/4800/ 9600
9600/19200
Odd/Even/none None
Yes/No
Input/output Output
ASCII/RTU RTU
Input Functions Output
Functions
05,15 01
02
04
06,16 03
Comments
Register address entry.
An3135 mimic, point or alarm state
data.
Parity type
Send alarm control (ACK, RST) data
1 bit per point to designate Tx/Rx data
Series 90B ANNUNCIATOR INSTALLATION AND CONFIGURATION MANUAL