14 WHEELS, TIRES
14.3
102
H00935-10
F02420-11
Removing rear wheel
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease shaft seal rings
of the spacers. Clean and grease the radial shaft seal rings and
the contact surface of the wheel spindle.
Long-life grease (
p. 166)
–
Insert the spacers.
–
Position front wheel and insert wheel spindle
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
Info
Ensure that the grip of the wheel spindle does not con-
tact with the right fork leg.
–
Operate the hand brake lever several times until the brake lin-
ings are seated correctly against the brake disc.
–
Remove motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
4
5
Tighten screws
and
Guideline
Screw, fork stub
Preparatory work
–
Raise the motorcycle with a lift stand. (
1
and contact surfaces
2
.
3
.
M24x1.5
45 Nm (33.2 lbf ft)
p. 55)
.
M8
15 Nm (11.1 lbf ft)
p. 55)
A