Installing The Rear Wheel - KTM 450 Rally Factory Replica 2021 Owner's Manual

14 WHEELS, TIRES
14.4
104

Installing the rear wheel

Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
S03060-10
S03059-10
F02421-10
Main work
–
Check rear hub damping rubber pieces.
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease shaft seal ring
the spacer.
Long-life grease ( p. 166)
–
Insert a spacer.
–
Clean and grease the spacers of the rear sprocket carrier.
Long-life grease ( p. 166)
–
Insert rear sprocket carrier
–
Position rear wheel and insert wheel spindle
The brake linings are correctly positioned.
–
Mount the chain.
–
4
Position chain adjuster
it yet.
–
Make sure that the chain adjusters are fitted correctly on the
6
adjusting screws .
–
Check chain tension. (
–
5
Tighten nut .
Guideline
Nut, rear wheel spin-
dle
Info
The wide adjustment range of the chain adjusters
enables different secondary ratios with the same chain
length.
4
Chain adjusters
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
( p. 105)
1
and contact surface
2
into the rear hub.
3
.
5
. Mount nut , but do not tighten
p. 78)
M25x1.5 80 Nm (59 lbf ft)
can be turned by 180°.
A
of