12.38
Checking the frame
–
Check chain sliding piece for wear.
»
If the lower edge of the chain pins is in line with or below
the chain sliding piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
»
If the chain sliding piece is loose:
–
Tighten the chain sliding piece.
Guideline
Screw, chain slid-
ing piece
F02408-10
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
»
If the chain guide is worn:
–
Change the chain guide.
–
Check that the chain guide is firmly seated.
»
If the chain guide is loose:
L03083-10
–
Tighten the chain guide.
Guideline
Remaining screws,
chassis
Remaining nuts,
chassis
Finishing work
–
Remove motorcycle from the lift stand. (
–
Check the frame for damage, cracks, and deformation.
»
If the frame shows signs of damage, cracks, or deforma-
tion:
–
Change the frame.
Guideline
Repairs on the frame are not permitted.
L03160-10
SERVICE WORK ON THE CHASSIS 12
M8
M6
M6
15 Nm
(11.1 lbf ft)
10 Nm
(7.4 lbf ft)
10 Nm
(7.4 lbf ft)
p. 55)
81