Table of Contents
Advertisement
Automatic Tile Holder
The internal tile holder automatically positions calibration and check tiles at the measurement port at a
distance equal to that of the product being measured. This holder is attached to the sensor housing.
Along with the black and white standardization tiles, it also holds a green ceramic check tile and the
fluorescent tile in systems with the optional source ultraviolet (UV) control. The presence of a tile
holder is automatically detected at power-up or instrument reset.
The tile holder contains two motors, one for opening and closing the tile drawer, and one for rotating the
platter on which the tiles are held. Up to four tiles may be stored in the holder at any given time. Tiles
to be read and/or used in standardization may be placed wherever desired in the tile holder, although
default positions are indicated in the software.
The tile
holder in the
open position
Manual Sample Holder
The manual sample holder snaps onto the sensor using ball studs and ball detents and has a spring-
loaded sample clamp to hold small samples and standardization tiles in the proper position under the
viewing window. The sample clamp is adjustable toward and away from the viewing window with its
spring action and the clamp arm rotates away from the viewing window for measurement of large
samples.
Ball studs
Side view
Installation area with two ball studs
11/02
Introduction
1-9
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Advertisement
Table of Contents
