Chapter 6 Melsoft Connection Mode Setting - Mitsubishi Electric MELSEC-A Series User Manual

6
MELSOFT CONNECTION MODE SETTING

CHAPTER 6 MELSOFT CONNECTION MODE SETTING

This chapter describes the setting example per programmable controller CPU of the
master station when the MELSOFT connection mode is used.
The following shows the system configuration of the setting example described in this
chapter.
Master station
Station No.0
Terminating resistor
Remote I/O station
Station No.1
Occupies 1 station.
CC-Link
(a) Master station
Item
Station No.
Transmission speed of data link
CC-Link version
Start I/O No.
All connect count
(b) Remote I/O station
Table 6.2 Information of remote I/O station
Item
Station No.
Transmission speed of data link
CC-Link version
No. of occupied stations
(c) AJ65BT-R2N
Item
Station No.
Transmission speed of data link
CC-Link version
No. of occupied stations
Mode setting switch
AJ65BT-R2N
Station No.2
Occupies 1 station.
Terminating resistor
Figure 6.1 System configuration
Table 6.1 Information of master station
Mounting position of master module
Table 6.3 Information of AJ65BT-R2N
Engineering tool
RS-232
Description
0
156kbps
Ver. 1
2
Description
1
156kbps
Ver. 1
Occupies 1 station
Description
2
156kbps
Ver. 1
Occupies 1 station
5 (MELSOFT connection mode)
1
2
3
4
5
6
7
6
- 1