6
MELSOFT CONNECTION MODE SETTING
6.3
Setting When ACPU/QCPU (A mode) is Used
This section describes the setting example when the programmable controller CPU of the
master station is the ACPU or QCPU (A mode).
Set switches of master module, remote I/O
module and AJ65BT-R2N.
Connect GX Developer to programmable
controller CPU on master station.
Set parameters.
Set communication route in [Transfer Setup] of
GX Developer, and perform communication test.
Start
End
Figure 6.15 Setting procedure
6.3 Setting When ACPU/QCPU (A mode) is Used
Section 6.3.1 Switch settings of each station
Section 6.3.2 Parameter setting
Section 6.3.3 Connection target setting
1
2
3
4
5
6
7
6
- 15