Specifications - Generac Power Systems Power Zone PZCONSVR Owner's Manual

General Information

Specifications

Environmental Specifications
Operating Temperature
Humidity
Sealing
Enclosure
Weight
Power Supply Requirements
Power Supply Voltage
Power Supply Usage
Power Supply Cable
Communication (Ethernet)
Number of Ports
Communication Link
Communication Cable
Maximum Cable Length
Baud Rate Auto-Detect
Communication (RS-485)
Number of Ports
Communication Link
Communication Cable
Maximum Cable Length
Baud Rate
Maximum Number of Devices
Protocol/Device Type
Communication (USB)
Number of Ports
Connector
USB version
Maximum Cable Length
Baud Rate
Communication (Wi-Fi and Bluetooth)
Supported Antenna Type
Wi-Fi
Bluetooth
Antenna (Wi-Fi and Bluetooth)
Type
Frequency Band
Gain
Distance
LED
Number of LEDs
Color
NOTE: The Ethernet, RS-485, and USB cables should not be run in the same conduit or in the same wire grouping as
any high voltage or high current conductors.
NOTE: The RS-485 settings such as baud rate should be selected to be compatible with other components that are
connected to the RS-485 bus.
* Use Extension Kit (part no. A0000310806) to connect Power Zone Pro Main Controller to Connectivity Server when
Connectivity Server is mounted outside the generator enclosure.
4
-4 °F (-20 °C) to 140 °F (60 °C)
5% to 90% non-condensing
IP65 rated
UL Type 3R
0.5 lbs
11 to 13 V (12 V nominal)
1.1 A (maximum during power up)
2 wires - 16 AWG recommended
1
4 wires minimum of 8 pin connector - 2 wire Receive and 2 wire Transmit
Cat5e – 2 twisted pairs
328 ft (100 m)
10/100 Mbps
1
2 wires
2 wires - shielded twisted pair (i.e. Belden 3105A)
4,000 ft (1,219 m)
115.2 kbps
32
Modbus/Master
1
Type A
USB 1.1/2.0
16.5 ft (5 m)
12 Mbps, 480 Mbps
2.4 Ghz Wi-Fi/Bluetooth
802.11 b/g/n (2.4 Ghz)
4.1
Internal on-board chip antenna
2.4 Ghz
1.5 dBi max (2.4 Ghz)
20 ft (6.1 m) inside generator enclosure, 200 ft (61.0 m) outside generator enclosure*
2
Red and green
Owner's Manual for Power Zone Connectivity Server