Flexible Flat Cable - Sony EVI-D100 Service Manual

1-5. Flexible Flat Cable

1. Remove the pan cabinet (side). (Refer to Section 1-2-1)
2. Remove the pan cabinet (front). (Refer to Section 1-2-2)
3. Remove the pan cabinet (rear). (Refer to Section 1-2-3)
4. Remove the camera cabinet (upper/lower). (Refer to
Section 1-2-4)
5. Remove the camera cabinet (front). (Refer to Section
1-2-5)
6. Remove the cabinet base (front). (Refer to Section 1-2-6)
7. Remove the camera block. (Refer to Section 1-3)
8. Remove the cabinet base (rear). (Refer to Section 1-2-7)
9. Remove the MDR-16/SE-616 boards. (Refer to
Section 1-4-8)
10. Remove the three screws (2x4), then remove the tilt
chassis.
11. Remove one screw (2x4), then remove the three
flexible flat cables and cable retainer from the DC
motor.
12. Remove the three hooks from the cable cover (lower),
then remove the cable cover (lower).
13. Remove the three screws (2.6x4), then remove the
cable guide assembly.
EVI-D100/EVI-D100P
2x4
Hook
Hook
2.6x4
2x4
Cable retainer
Fig.A
14. Connect the flexible flat cable in the reverse order of
steps 1 to 13.
Tilt chassis
Cable cover (lower)
Projections
Hook
Projections
Cable guide assembly
DC motor
Flexible flat cable
1-11