Rear Board Assembly - Sony EVI-D100 Service Manual

1-4-7. Rear Board Assembly

1. Remove the pan cabinet (side). (Refer to Section 1-2-1)
2. Remove the pan cabinet (front). (Refer to Section 1-2-2)
3. Remove the pan cabinet (rear). (Refer to Section 1-2-3)
4. Remove the cabinet base (front). (Refer to Section 1-2-6)
5. Remove the cabinet base (rear). (Refer to Section 1-2-7)
6. Remove the three screws (M2.6x4), then remove the
base plate.
7. Remove the two screws (M2), then remove the rear
board assembly.
8. Disconnect the two flexible flat cables from the two
connectors on the IF-834 board.
Rear board assembly
Base plate
M 2.6x4
EVI-D100/EVI-D100P
Connectors
IF-834 board
Flexible flat cables
M 2
9. Remove one screw (M2), then remove the SW-1074
board and two buttons from the CN chassis.
10. Disconnect one harness from the connector on the SW-
1074 board and IF-834 board.
11. Remove the two screws (2x4), then remove the IF-834
board from the CN chassis.
M 2
Connector
Harness
2x4
12. Attach the rear board assembly in the reverse order of
steps 1 to 11.
Button
SW-1074 board
CN chassis
Connector
IF-834 board
1-9