Mdr-16/Se-616 Boards - Sony EVI-D100 Service Manual

1-4-8. MDR-16/SE-616 Boards

1. Remove the pan cabinet (side). (Refer to Section 1-2-1)
2. Remove the pan cabinet (front). (Refer to Section 1-2-2)
3. Remove the pan cabinet (rear). (Refer to Section 1-2-3)
4. Remove the cabinet base (front). (Refer to Section 1-2-6)
5. Remove the cabinet base (rear). (Refer to Section 1-2-7)
6. Remove the rear board assembly. (Refer to Section 1-
4-7)
7. Remove the four screws (2.6x4), then remove the base
chassis.
8. Remove the three screws (2x4), then remove the
MDR-16 board.
9. Disconnect one harness and five flexible flat cables
from the six connectors on the MDR-16 board.
2.6x4
Connectors
MDR-16 board
2x4
Base chassis
1-10
10. Remove the two screws and disconnect one harness
11. Attach the MDR-16/SE-616 boards in the reverse
2.6x4
Flexible flat cables
Connectors
Harness
from the connector on the SE-616 board, then remove
the SE-616 board.
SE-616 board
Connector
Harness
order of steps 1 to 10.
M 2x3
EVI-D100/EVI-D100P