Sony EVI-D100 Service Manual page 46

9. Color Reproduction Adjustment
Adjust the color separation matrix coefficient so that
proper color reproduction is produced.
Subject Color bar chart standard picture
frame
Pin !- of CN501
Measurement Point
Measuring Instrument Vectorscope
Adjustment Page F
Adjustment Address 34, 36, F5, F6
Specified Value All color luminance points should
settle within each color reproduction
frame.
(Last page of this manual)
NTSC model: EVI-D100/D100C
PAL model: EVI-D100P/D100CP
Adjusting method
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 2, address: 01, set data: 3D, and press the
PAUSE button of the adjusting remote commander.
3) Select page: F, address: 25, set data: 3F, and press the
PAUSE button of the adjusting remote commander.
4) Adjust the GAIN and PHASE of the vectorscope, and
adjust the burst luminance point to the burst position
of the color reproduction frame.
5) Change the data of page: F, address: 34, 36, F5 and F6,
and settle each color luminance point in each color
reproduction frame.
n
Be sure to press the PAUSE button of the adjusting
remote commander before changing the of addresses.
If not, the new data will not be written to the memory.
6) Press the PAUSE button of the adjusting remote
commander.
Processing after Completing Adjustments
1) Select page: 2, address: 01, and set data: 00, and press
the PAUSE button of the adjusting remote commander.
2) Select page: 0, address: 01, and set data: 00.
2-22
For NTSC model
Burst position
For PAL model
Burst position
EVI-D100/EVI-D100P