Trouble Shooting; Self-Diagnosis Function; Note On The Function Of Boards; Self-Diagnosis Code Table - Sony Handycam HDR-CX450 Service Manual

1-1.

Self-diagnosis Function

1-1-1. Self-diagnosis Function
If an error occurs in this unit, the self-diagnosis function starts working and a code consisting of one alphabet and a four-
digit number appears on the LCD. Classification of persons in charge, classification of faulty blocks, and details of errors
can be checked by referring to this indication of five alphanumeric characters in the self-diagnosis code table.
The history of past errors can be checked in "Usage and Diag record" on the DATA tab of the Adjust Manual.
The self-diagnosis function is also described in the operation manual.
1-1-2.

Note on the Function of Boards

The boards and functions used in this model are mentioned in the following table.
Board Function
CM board Imager
MM board Internal memory
WF board Wireless LAN module
JK board PITCH/YAW angular velocity sensor
PD board LCD control
VC board CPU, Power, Lens drive, ROLL angular velocity sensor, Other function
1-1-3.

Self-diagnosis Code Table

Self-diagnosis Code
Block
Detailed
Function
Code
C 0 4 0 0
C 0 6 0 0
C 1 3 0 1
C 1 3
0 2 *1
C 1 3 *1
0 3
C 1 3 *1
0 4
C 3 2 6 0
E 2 0 0 0
E 3 1
0 0 *1
*1: Function of this code is not provided in this unit.
*2: Start the Adjust Manual in the Adjust Station and execute the "Destination data write" on the ADJUST tab.
HDR-CX450/HDR-CX455/HDR-CX485
Section 1

Trouble Shooting

Symptom/State
Non-standard battery is used.
The battery pack temperature is
high.
Memory card is unformatted or
memory card is broken.
Access error
Access error (External media)
Abnormality of the drive (External
media)
Difficult to adjust focus
(Cannot initialize focus)
Flash memory data are rewritten.
Abnormality of the drive
Correction
Use the InfoLITHIUM battery.
Change the battery pack or place it in a cool place.
Format the memory card.
Insert a new memory card.
Remove the power source. Reconnect it again and operate
the unit again.
Turn power off and turn power on again.
Turn power off and turn power on again.
Turn power off and turn power on again. When this error is
not cleared, the focus control signal for the lens block may
be faulty.
Check whether this error is due to the lens or the board.
Replace the faulty lens or board.
Make flash memory data correct value.
Turn power off and turn power on again.
*2
Continued
1-1