Raco Schwelm T6C2 Translation Of The Original Instruction page 40

Setting of a position in the EPS02:
This is only necessary in case of an incorrect activation of the Set Zero Position button.
Determine the current position from the position of the thrust tube and the manufacturers
a3.dimension (mounting dimension). If in doubt keep always consult with the manufacturer.
Risk of damage!
Entering incorrect position values may lead to serious errors in the
RACO cylinder or in the system!
The parameterization may only be performed by specialist personnel.
WARNING!
First, the current position of the cylinder in the RACO Tool has to be stored. Therefore press in the
"Setup" menu the function „Memory Position (old module)".
Point the cursor to the headword „Memory" and by right-clicking on the mouse a popup box will appear
on the screen:
Revision: 05
5.2-9/11
The position will be stored.
154-625-2