Advertisement
Set-up mode 2: Switch-off position in the extended state
The green and yellow LED will flash until the retracted position is exited.
The yellow and red LEDs are off, the green LED flashes.
In this mode (green LED flashes), the limit switch position for the extended state can be set.
The cylinder must now be moved to the required extended position and the outer button S2 pressed to
confirmation for at least 1 second. If switch-off values which lead to the drive switching off when ex-
tended are already present in the module, this can be bridged by keeping button S2 pressed for longer
than one second.
If you do not require any change to the position for switch-off extended state, button S2 does not need
to be pressed.
Now keep button S1 pressed for longer than 1 second. You will now leave the set-up mode completely
and change to normal operation mode.
Note:
A Windows RACO Setup Tool is optionally available to configure all functions of the EPS02.
This software tool is available from RACO on data carriers
(143-833-6)
or in the download area of our
website. The optional interface converter with the part number 149-769-3 or 161-904-7 is required for
the parameterization. We recommend an additional USB isolator to avoid earth loops, compensating
currents and to protect against overvoltage.
The parameter kit EPS02 (162-149-1) includes the CD
with the software tool (143-833-6) as well as the interface-converter (161-904-7).
5.2-5/11
Revision: 05
154-625-2
Hide quick links:
Advertisement
