Installing Matrox Meteor-Ii /Digital For Pc/104-Plus - Matrox Meteor-II /Digital Installation And Hardware Reference

d. Replace the cover of your computer.
e. Connect your video sources. For details, see the
Connecting external devices section.
f. Turn on your computer.
In some cases, when you boot your computer, Windows'
Plug-and-Play system will detect a new PCI card and you
will be asked to assign a driver to it. At this point, you
should click on Cancel because the driver will be installed
during the installation of MIL or one of its derivatives.

Installing Matrox Meteor-II /Digital for PC/104-Plus

Use the following steps to install your Matrox Meteor-II board
for PC/104-Plus:
1. Matrox Meteor-II for PC/104-Plus can operate in either a
5V or 3.3V system. In some cases, a hole in the PC/104-Plus
(PCI) connector is filled, which prevents another
PC/104-Plus board from being stacked on top. To install
Matrox Meteor-II for PC/104-Plus in a system with a
specific signalling environment, a pin must be removed.
The table and diagram below indicate which pins to cut, and
their locations on the connector.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Installing Matrox Meteor-II /Digital
Signalling Pin to remove
on J3 connector
environment
5V A1
3.3V D30
21