Siemens SIMOTICS T-1FW3 Configuration Manual page 120

Configuration
5.4 Mounting
Mounting sequence, Siemens torque arm with clamping element
Procedure
1. Check the rotor and prepare the shaft seat:
1
2
3
4
5
Figure 5-15
118
Clamping seat: must be free of any lubricant
Centering seat: Apply assembly paste, e.g. Molykot
Clamping screws (all of the screws shown in green in this diagram)
Forcing-off screws: Remain for removal, tightened as when originally delivered
The values are in the dimension drawings in this chapter
As delivered state and preparations for mounting
1FW3 complete torque motors
Configuration Manual, 08/2020, A5E46027705B AA