Digital Speed Controls; General; Cruise Mode; Cruise Mode Limitations - Scarab SB Series Owner's Manual

Table of Contents

Advertisement

Should the engine be shut off, boat directional
control is not available. Never leave the key
in the ignition and the cord connected to the
engine cut-off switch when boat is not in op-
eration to avoid unauthorized use by children
or theft.
NOTICE
DO NOT stop engine at speeds above idle or
"speed up" engine while turning off ignition.
Engine damage could result.
Should the boat be left unattended, be sure to
remove the key from the ignition to avoid possible
unauthorized use or theft.
D - 6

DIGITAL SPEED CONTROLS

A. General
The following descriptions and images depict a single
engine Digital Speed Controls features and switch
locations. The Digital Speed Controls for twin engines
follow the same procedures as well as having the
same features. Switch locations do vary. Certain
Digital Control features may be optional.
NOTE: These operating modes do not resume if en-
gine was stopped
B. Cruise Mode
It is not recommended to use the CRUISE
mode when pulling a tube, skier or wakeboard-
er. Maintain your speed manually or use the
SKI MODE.
CRUISE mode is a function of DSC (Digital Speed
Control) system that allows to maintain a steady
speed while riding the boat. It will prevent the boat
from going above a set speed limit. This is useful
when cruising for long distances or operating in limited
speed zones.
Operation - Section D
NOTICE
The boat speed may vary slightly depending
on the weather or water conditions such as the
wind or waves.
The CRUISE mode is designed to be used for pro-
longed drives on open waters.
Improper use of the CRUISE mode can lead
the boat to a loss of control.

1. Cruise Mode Limitations

The CRUISE mode is not an automatic pilot, it will not
drive the boat. The CRUISE mode does not anticipate
for obstacles, other users, objects, etc, and will not
steer or stop the boat.

2. Setting the Cruise Mode

NOTE: To use the CRUISE mode, the boat speed
must be above approximately 10 km/h (6MPH).
To activate the CRUISE mode:
a. Using the throttle/shifter lever or throttle lever,
bring the boat at the speed you want to maintain.
b. Press MODE button repeatedly until CRUISE
mode is displayed. See Figures D7, D8 & D9.
"ADJUST" (Up/Down) Switch
"MODE" Switch
Figure D7: Digital Speed Control Switch
"SET"Switch
Owner's Manual Page 99

Advertisement

Table of Contents
loading

Table of Contents