Scarab SB Series Owner's Manual page 62

Figure B22: Helm Switches w/LED
To avoid electrical problems, equipment damage
or electrical fires, use only replacement fuses or
breakers that are of equal rating to the originals.
To assist you, we have listed the descriptions of
individual switch e s, receptacles and their uses:
Accessories - Additional 12-Volt equipment may be
added to the boat by using the accessory switches
(ACC) if equipped. Certain options or accessories
may be wired to the battery switch.
NOTE: Rotax engines are equipped with a station
charging system with limited charging ability. Select
only low amperage or intermittent accessories.
12-Volt DC Receptacle - Permits the use of additional
12-Volt equipment such as a cell phone. Using the
appropriate adaptor, the equipment draws power from
either the engine start battery or ship's system battery
if applicable. A 12-Volt DC receptacle is located inside
the port helm glove box on certain models. See Figure
B23.
Boat Systems - Section B
LED
Aft Bilge Pump - The BILGE switch (Figure B24) is
used to manually activate the bilge pump in the engine
compart ment (after cleaning, storage, etc.). The bilge
pump is used to remove water from the bilge (bottom
of the hull) area of the boat by pumping that water
over board.
12-Volt DC Receptacle
Figure B23: 12-Volt DC Receptacle
(Location May Vary Depending on Model)
Bilge Pump
Bilge Blower
Figure B24: Starboard Helm Switches
Representation only - Models May Vary)
NOTICE
Do not operate for prolonged time if the bilge is
dry. Battery drainage will occur and pump will be
damaged.
NOTICE
Always turn pump OFF after water is evacuated
or before operating the engine above idle.
Bilge pump will then switch to automatic mode.
Courtesy Lights
Owner's Manual Page 58