Porta-Potti W/Pumpout - Scarab SB Series Owner's Manual

Emptying of Portable Models:
1. Empty when waste holding tank level appears full.
DO NOT ALLOW THE TANK TO BECOME OVER-
FILLED.
2. Make sure waste valve handle is in the closed
position.
3. Remove fresh water tank from waste holding tank
(Figure B54-A & B).
Figure B54 (A-B) Removing Fresh Water Tank
4. Remove waste holding tank from hold down
brackets.
5. Carry the waste holding tank to any permanent
toilet facility. Rotate the pour-out spout to the
desired position. Remove the cap. Depress the air
relief valve with your thumb while emptying (Figure
B55).
Figure B55: Emptying Waste Holding Tank
6. Rinse waste holding tank and recharge as
described under preparation portion of this section.
7. Reassemble unit and fasten to floor or deck.
C. Porta-Potti w/Pumpout
If equipped, the waste holding tank should be emptied
when waste holding tank level gauge indicator on the
porta-potti (models with pumpout only) has changed
from green to red (Figure B56). DO NOT ALLOW THE
TANK TO BECOME OVERFILLED.
Boat Systems - Section B
Figure B56: Porta-Potti Level Gauge Indicator
With the head pumpout, the waste can be removed
from the tank at a pumping station. A deck plate fitting
labeled "WASTE" is provided for this pur p ose. See
Figure B57. Most mari na fueling facilities provide
servic e for waste pump out. For waste holding capaci-
ties, please refer to the manufacturer's literature and/
or our website.
Figure B57: Pumpout Waste Deck Fitting
To pump out the holding tank:
1. Connect the dockside pump out connection to the
WASTE plate located on the deck.
NOTICE
Usual ly the dockside pump out connection will
screw into the waste deck plate or has a rubber
sleeve that inserts into the plate and must be
held in position during the pump out operation.
2. Have the pumping station operator activate the
pumping equipment. The waste will be drawn from
the holding tank and into the pumping stations
disposal tank.
3. Remove the pump out con nection from the deck
plate. Add 1 gallon of clean water to the holding
tank through the waste deck fitting using a dock-
side water hose.
4. Repeat steps 1 & 2 above to pump out the water
used in step 3 to flush the holding tank.
Owner's Manual Page 75