Table of Contents
Advertisement
E - 8
ACRYLIC PLASTIC - (Plexiglass)
Acrylic plastic may be utilized in such things as
storage doors and walk-thru doors.
To clean acrylic plastic:
1. Rinse with plenty of water to wash off as much dirt
as possible.
2. Using your bare hand, along with plenty of water,
feel and remove any dried-on dirt or mud.
3. Wash using a soft, grit-free cloth or sponge and
mild, nonabrasive soap or detergent.
4. Rinse thoroughly with water.
5. Blot dry using a clean, damp chamois.
NOTICE
Never use a dry cloth, duster, glass cleaning
solutions or citrus cleaner on acrylic plastic.
NOTICE
Do not use solvents such as acetone, silicone
spray, benzine, carbon tetrachloride, fire ex
tinguisher fluid, dry cleaning fluid, lacquer
thinner or ammonia. These solutions damage
the acrylic surface.
You can use fine automotive acrylic rubbing and
polishing compounds to remove fine scratches on
acrylic. Always read the label before using any
product.
E - 9
SWIM PLATFORM MAT
Available for the swim platform is a mat available. See
Figure E2. This mat is bonded to the fiberglass swim
platform using adhesive and is typically installed by
Scarab. This mat provides a comfortable surface for
enjoying those watersport activities.
Care and Maintenance - Section E
Figure E2: Swim Platform Mat
Swim platform care instructions:
1. If possible keep covered while in storage or not in
use.
2. Spills: Scoop or scrape up as much of spill as
possible and follow by blotting the remaining spot
with a dry clean cloth. Paper towel can be substi-
tuted when cloth is not available.
3. Non-Oil Based Stained: Make a detergent solution
by adding a ¼ inch teaspoon liquid dish detergent
to I cup warm water. Apply solution to the affected
area and blot - (DO NOT SCRUB) with a dry clean
cloth, repeat process until stain stops transferring
to the cloth. If stain still appears, apply solution to
area let stand 2-5 minutes and rinse with clean
water.
4. Oil Based Stains: Apply Naphtha or mineral spirits
to effected area and follow the instructions on the
solvent container. - Always work the stain from the
outside toward the center - (DO NOT SCRUB).
5. If Stain Still Appears: Surface can be restored
by lightly sanding area with 24-36 grit sandpaper.
(Sanded area may appear slightly lighter but it will
blend over time).
E - 10 UPHOLSTERY CARE
A. Cleaning Vinyl
NOTICE
Vinyl upholstery should be cleaned and main-
tained in accordance with the manufacturer's
recommendations and instructions.
Owner's Manual Page 114
Advertisement
Table of Contents
