Table of Contents
Advertisement
D - 1
PRE-CRUISE INSPECTION
This boat may exceed the performance of
other boats you may have driven in the past.
Take time to familiarize yourself with your new
boat.
The pre-cruise inspection is very important
before operating the boat. Bring all safety
equipment required by local laws. Perform a
pre-cruise inspection before each ride to detect
potential problems during operation. The pre-
cruise inspection can help you monitor wear
and deterioration before they become a prob-
lem. Correct any problems that you discover
to reduce the risk of a breakdown or accident.
See an authorized Scarab dealer if necessary.
Note: Pre-cruise inspection should be conducted
daily at the first start up.
A. Before Starting the Engine
1. Inspect the hull for damage. Clean as required.
Excessive dirt or marine growth will effect your
boat's performance and fuel efficiency.
2. Inspect jet pump water intakes. Remove any
blockages.
3. If your boat has been out of the water, check to
see that all bilge water has drained out. Install hull
drain plugs.
4. Check all deck hardware to include tower and
bimini top (if applicable) for serviceability. Tighten
fasteners as needed.
5. Open engine compartment. Inspect for fuel odors
and visible leaks in the fuel, oil, coolant, and
exhaust systems. Visually inspect engine(s) for
cracked hose, defective belts, or other signs of
potential engine problems. If problem exists con-
tact your Scarab dealer immediately. Do not start
engine until issue is corrected. Check engine oil,
coolant and battery water levels. Check battery
electrolyte range.
Operation - Section D
6. If your boat has been in the water, Check the
bilge water level and bilge pump operation. Run
the bilge pump until the flow of water stops.
7. Oper ate the bilge blower for at least four (4) min-
utes before engine start-up. Check the blower
output.
Gasoline vapors can explode resulting injury or
death. Before starting the engine, check
engine compartment bilge for gasoline or
vapors. Operate blower for four minutes, and
verify blower operation. ALWAYS run the blow-
er when the vessel is operating below cruising
speed.
8. Check fuel level. Fuel tank(s) should be filled to
slightly less than capacity. Allow for fuel expan-
sion.
9. Check the operation of the electrical system and
navigation lights.
10. Check operation of steering system, control lever
and operation of horn.
11. Be sure all necessary safety equipment is on
board and in good working condition. Examples
include personal flotation devices (PFDs), horn,
fire extinguisher, visual distress signals, etc. Take
along extra drinking water. A Boating Safety
Checklist from the American Boat and Yacht
Council (ABYC) has been included at the front of
this manual to assist you with having the neces-
sary safety items on board your boat.
12. Check that other important equipment is on board.
Examples include mooring lines, anchor and line,
boat hook, tool kit, first aid kit, etc.
13. Make sure passengers and crew know what to
do in case of an emergency and how to operate
safety equipment.
14. Always keep accurate up-to-date charts of your
boating area on board. Make sure navigational
equipment is on board and functioning properly.
15. Make sure all required documents are on board.
Operation
Owner's Manual Page 90
Advertisement
Table of Contents
