Table of Contents
Advertisement
Figure D10: SKI MODE Displayed
b. Press the SET button once to enter SKI MODE.
The RAMP indication will be displayed. See Figure
D11.
Figure D11: RAMP Displayed (Ski Model)
c. Using the ADJUST (Up and Down) switch, select
the appropriate RAMP.
d. Press SET button to accept the selection.
e. Now determine the target speed using ADJUST
(Up and Down) switch. See Figure D12.
Figure D12: TARGET SPEED Displayed (Ski Mode)
Operation - Section D
f. Press SET button to confirm the speed. The
indication SKI MODE will be displayed with the
determined speed. See Figure D13.
Figure D13: SKI MODE Displayed (w/Target Speed)
g. Press the SET button again to activate the launch
sequence. At this time, the SKI MODE light blinks.
NOTE: In the launch sequence mode, the first 95% of
throttle/shifter lever travel is used to position
the boat and stretch the cord without engag-
ing the SKI MODE.
h. When everybody is ready (operator, watcher and
skier, tube rider or wakeboarder), push the throttle/
shifter lever or throttle lever to full throttle position.
The SKI MODE will be activated and the light turns
ON.
3. Temporarily Deactivating the Ski Mode
a. To deactivate the SKI MODE temporarily, move
the throttle/shifter lever to the NEUTRAL position
or move the throttle lever to IDLE and shift lever to
NEUTRAL and press the MODE button to return
to step 7 of SETTING THE SKI MODE. All of the
throttle/shifter lever or the shift lever and throttle
lever travel can be used without restriction. The
SKI MODE light will blink again and a beep will be
heard every 3 seconds.
b. To reactivate the SKI MODE, place the throttle/
shifter lever to NEUTRAL position move the
throttle lever to IDLE and shift lever to NEUTRAL
and press the SET button to return to step 8 of
SETTING THE SKI MODE.
Owner's Manual Page 101
Advertisement
Table of Contents
