Digital Speed Controls; Cruise Mode; Cruise Mode Limitations; Setting The Cruise Mode - Scarab jet boat Owenrs Manual

NOTICE
DO NOT stop engine at speeds above idle or
"speed up" engine while turning off ignition.
Engine damage could result.
Should the boat be left unattended, be sure to
remove the key from the ignition to avoid possible
unauthorized use or theft.
D - 6

DIGITAL SPEED CONTROLS

gine was stopped
A. Cruise Mode
It is not recommended to use the CRUISE
er. Maintain your speed manually or use the
SKI MODE.
CRUISE mode is a function of DSC (Digital Speed
Control) system that allows to maintain a steady
speed while riding the boat. It will prevent the boat
from going above a set speed limit. This is useful
when cruising for long distances or operating in limited
speed zones.
NOTICE
The boat speed may vary slightly depending
on the weather or water conditions such as the
wind or waves.
The CRUISE mode is designed to be used for pro-
longed drives on open waters.
Improper use of the CRUISE mode can lead
the boat to a loss of control.

1. Cruise Mode Limitations

The CRUISE mode is not an automatic pilot, it will not
drive the boat. The CRUISE mode does not anticipate
for obstacles, other users, objects, etc, and will not
steer or stop the boat.
Operation - Section D

2. Setting the Cruise Mode

speed you want to maintain.
b. Press MODE button repeatedly until CRUISE
mode is displayed. See Figures D4 & D5.
-
Toggle "UP" & "DOWN" Switch
-
Figure D4: Digital Speed Control Switches
Figure D5: CRUISE MODE Displayed
c. Press the SET button once, the following message
will be displayed "HOLD SET TO ACTIVATE OR
d. Hold the SET button until CRUISE mode reap-
pears. At this time, the CRUISE light blinks and
you hear one short beep.
e. Slightly move throttle lever forward until CRUISE
light turns ON and activate the CRUISE mode.
"SET"Switch
"MODE" Switch
Owner's Manual Page 83