Toyota 30 Series Manual page 65

Roller Adjustment at Lift Bracket
1.
(1) Bring the center of the side roller in the upper part of the
lift bracket to approx. 100 mm (3.94 in) from the top of
the inner mast.
(2) Remove side rollers.
(3) Shift the lift bracket to one side to bring the roller into
contact with the inner mast, and inspect on the opposite
side the clearance between the roller side face and the
mast where they are the closest. (No adjustment is nec-
essary for the upper lift rollers since they are fastened
by snap rings.)
Standard
=
C 0.5 mm (0
If the standard is not satisfied, make adjustment by chang-
ing the lift roller shim thickness.
Shim thickness: 0.5 and 1.0 mm (0.020 and 0.039 in)
lnner
mast
bracket
100 rnrn (3.94 in)
lnner
mast bracket
-
0.020 in)
4-1
5