Rear Axle Assy; Removal*Installation - Toyota 30 Series Manual

AXLE ASSY
REAR
REMOVAL- INSTALLATION
Removal Procedure
Remove the counter weight.
1
Apply the parking brake and chock the front wheels.
2
3 Jack up the frame and support it with the wooden block.
Remove the rear wheels (See removal procedure steps 2 to
4
page
3-7).
Disconnect the rear axle cylinder hose.
5
Support the rear axle ASSY with a garage jack.
6
Remove the rear axle ASSY. [Point I]
7
Remove the center pin bushing. [Point 21
8
Installation Procedure
The installation procedure is the reverse of the removal procedure.
Note:
After installation, add grease through each grease fitting. Add genuine molybdenum disulfide grease
at the rear axle beam center pins (two places). Use MP grease to other grease fittings.
T
=
in steering knuckle removal section on
4