Toyota 30 Series Manual page 60

Point Operations
Shim
[Point I ]
Disassembly:
Shim adjustment is made at the lift cylinder rod end for pre-
venting uneven lifting by lift cylinders LH and RH.
Take a note on the cylinder where the adjustment is made
and the number of shims in use.
[Point 21
Disassmbly:
Take a note on the number of cylinder support shims in use.
Reassembly :
Make cylinder support shim adjustment if the mast or either
cylinder is replaced.
With the cylinder rod end inserted to the inner mast, insert
nate the clearance. The shim thickness should be slightly
greater than the clearance.
[Point 31
Inspection:
Measure the mast strip thickness.
Thickness limit: A
=
2.7 mm (0.106 in)
B
1.3 mm (0.051 in)