Toyota 30 Series Manual page 15

Removal Procedure
Remove the mast. (See page 4-7)
1
Remove the battery hood Wldriver seat.
2
3 Remove the battery ASSY.
Jack up the vehicle and remove the front wheels.
4
Drain differential oil. [Point 11
5
Disconnect the drive motor wiring.
6
Disconnect the speed sensor sub-harness connector.
7
8 Disconnect the brake pipe (from the wheel cylinder).
9 Remove the front toe-board.
10 Disconnect the parking brake wires.
11 Remove the drive motor set bolts.
12 Support the front axle & drive motor ASSY with a hoist and garage jack. [Point 21
13 Remove the front axle bracket set bolts. [Point
14 Remove the front axle & drive motor ASSY.
15 Disconnect the drive unit and drive motor
16 Remove the front axle shaft. [Point
17 Remove the front axle housing Wlbrake.
18 Remove the speed sensor cover and the sensor.
Installation Procedure
The installation procedure is the reverse of the removal procedure.
Note:
Bleed air from the brake system after installation.
Point Operations
[Point 11
Installation:
After reassembly, fill hypoid gear oil to the specified level.
A 15 mm (0.59 in) or less
=