Toyota 30 Series Manual page 43

Point Operations
[Point 11
Installation:
Fill MP grease in the hub cap, and install by tapping the
flange portion.
[Point 21
Installation:
Adjust the rear wheel starting force.
1. Install the claw washer in the correct direction.
2. Install the castle nut and temporarily tighten it to a torque
of 15 to 32 N-rn (1 50 to 330 kgf-cm) [I 0.9 to 23.9 ft-lbfl.
3. Rotate the hub by 3 to 5 turns to run in the bearing.
4. Set a spring scale at the outer periphery of the wheel,
and measure the starting force.
Standards: 9.8
5. If the standard is not satisfied, adjust the degree of castle
nut tightening for adjustment.
6. Install a new cotter pin.
[Point 31
Installation:
Fill MP grease in the hub and knuckle spindle.
Installation:
Install the rear wheel and outer bearing.
SST 09370-20270-71
29 N (1.0 3.0 kg9 [2.2
-
6.6 Ibf]