Toyota 30 Series Manual page 41

Grease fitting
Point Operations
[Point I ]
Inspection:
Measure the rear axle front to rear clearance.
1. Before removing the rear axle ASSY, measure the front
2. If the measured value does not satisfy the standard, re-
First
I
Second
[Point 21
Inspection:
Inspect the inside diameter of the rear axle center pin bush-
ing.
Limit: 52.0 mm (2.047 in)
Installation:
Apply molybdenum disulfide grease on the bushing and in-
stall the bushing by aligning the grease groove in the bush-
ing with the grease fitting position.
to rear clearance on the rear side.
Standard clearance: 0.7 mm (0.028 in) or less
move the rear axle ASSY and make adjustment by se-
lecting the spacer.
Spacer thickness:
The first spacer shall be installed with its chamfered at
the inside diameter in contact with the center pin boss.
and 0.1 97 in)